• <sup id="6ques"><button id="6ques"></button></sup>
  • <sup id="6ques"></sup>
  • <sup id="6ques"><button id="6ques"></button></sup>

    CN | EN

        • Fiber Optic Intrusion Detection System

        • Fiber Optic Intrusion Detection System Solution

        • Fiber Optic Intrusion Detection System Classic Case Series

        • Fiber Optic Intrusion Detection System Video Introduction

      • HD-SDI Surge Protector
        RV705 HD-SDI Surge Protector

        4U Rack Mounting Chassis
        RV600C HD-SDI 4U Rack Mounting Chassis

        4U Rack Mounting Chassis
        RV600C HD-SDI 4U Rack Mounting Chassis

        HD-SDI Surge Protector
        RV705 HD-SDI Surge Protector

        • HIFI Audio Optical Transceiver

          ● RV6X4-2A         2-ch unidirectional HIFI
          ● RV6X4-4A         4-ch unidirectional HIFI
          ● RV6X4-4A-1U    4-ch unidirectional HIFI-1U
          ● RV6X4-8A         8-ch unidirectional HIFI
          ● RV6X4-2A-2BA   2-ch bidirectional HIFI
          ● RV6X4-4A-4BA   4-ch bidirectional HIFI

          ● Compact design with 1U height
          ● XLR interface for Audio
          ● SNR is better than 92dB
          ● 192K sampling frequency
          ● 24 bit quantized accuracy
          ● Provides AC110~220V dual power redundancy

        • SDI Converter

          ● 75ΩBNC connector for SDI input and looping out
          ● VGA output interface
          ● Two unbalanced RCA audio output with 600Ω impendence...

          ● Features 1 VGA input, 2 audio inputs and 1 SDI output
          ● Supports asymmetrical conversion for any format
          ● The input and output video format can be shown on the screen...

          75Ω BNC connector for SDI input and looping out

          ● HDMI output interface

          ● Two unbalanced RCA audio output with 600Ω impendence...

        • SDI Distribution Amplifier

        • 4U Rack Mounting Chassis

          ● 19 inch and 4U height
          ● 16 traffic card slots and 1 management card slot
          ● 3 fans embedded
          ● Dual power supplies for power redundant protection
          ● Provides one RS232 management interface(CONSOLE) used for CLI management...

        • HD-SDI Surge Protector

          and Pattern Generator

          ● Multi-level protection, low residual voltage
          ● Short response time   
          ● Large thermal capability and low limiting voltage
          ● Stable performance and long service life...

          ● Comply with SMPTE-424M 3G-SDI, SMPTE-292M HD-SDI and SMPTE-259M SD-SDI standard
          ● Support 1080P@59.94/29.97, 1080I@59.94, 720P@59.94, 525I@59.95 format of NTSC...

        • CHIP

        • Multi-Service Access Platform

          3U height, 19 Inch width standard, 9 card slots.

          Up to 2 GE optical ports and 2 GE electrical ports

          Aggregate the 1000M Ethernet traffic from up to 3 downlink cards...

          ● 7U height, 19 Inch width standard, 16 card slots.

          ● Up to 4 GE optical ports and 4 GE electrical ports.

          ● Each card can aggregate the 1000M Ethernet traffic from up to 8 downlink cards...

        • Converter

        • Compact SDH

        • Compact PDH

        • Channelized Industrial Ethernet switch

          Optical interface
          ● Two optical interfaces; SFP optical module (LC interface); Hot plugging...
          Ethernet interface
          ● RP105SA:One fiber and two copper Gigabit Ethernet interfaces
          ● RP106: Four fast Ethernet interfaces...

      • CONTACT US

      • Mobile: 86-13810132168
      • Tel: 86-10-80106100-157
      • Skype ID
      • live:d8d61896f81afc11
      • 服務時間

      • 周一至周五 9:00-18:00
      • WeChat qr code

    RS1030
    12161299
    RS1030

    PCM Multi-service Optical Terminal (RS1030)

    RS1030 is designed as a STM-1 level optical terminal with two 155.520Mb/s optical interfaces to provide an ultra-compact, cost-effective and flexible multi-service platform. It can realize the E1 (up to 8E1), V.35, PCM traffic and 100Mbps Ethernet transmission over optical line.
    • 999999999999999

       

       

      Overview   

       

      RS1030 is designed as a STM-1 level optical terminal with two 155.520Mb/s optical interfaces to provide an ultra-compact, cost-effective and flexible multi-service platform. It can realize the E1(up to 8E1), V.35, PCM traffic and 100Mbps Ethernet transmission over optical line.

      RS1030 supports port-based VLAN and IEEE 802.1Q tag-based VLAN. By adopting ITU-T G.7041, G.7042 and G.707-compliant EOS (Ethernet Over SDH) technology and VLAN technology, each Ethernet port can employs 1~4 separate Virtual Concatenation Groups (VCG), and each VCG can be assigned to one or more Ethernet ports. The bandwidth of VCG can be flexibly configured for efficient transmission of Ethernet data over SDH network.

      RS1030 supports NE management based on CLI command and RayView network management platform based on SNMP_V1 and SNMP_V2 protocol, to perform excellent management such as configurations, alarm monitoring and performance statistic. 

      RS1030 is suitable for data access network on the client side. With the technology compliant to ITU-T standards, it can communicate with products from other vendors adopting the same standards.

       

      Feature

       

      • Standard rack with 1U height and 19 Inch width
      • Cross-connection with TU-12 granularity
      • Optical Interface
      • Two STM-1 interfaces, LC type SFP module , hot pluggable
      • Complies with GB/T15941-1995 and ITU-T G.813 standards
      • Supports RPD (Remote Power down Detection) information sending function
      • Supports ALS (Automatic Laser Shutdown) to protect operators from hurt
      • One card slot for 4 / 8E1 card or 2E1+V.35 card or 8E1+8PCM / 16PCM card 
      • E1 Interface
      • Up to 8E1
      • Optional 120Ω balanced E1 interface / 75Ω unbalanced E1 interface
      • E1 interface complies with ITU-T G.703 standard
      • V.35 Interface
      • DB25 connector, complies with ITU-T V.35 standard
      • V.35 interface supports non-framed and framed mode, the bit rate is N×64KbpsN=131in framed mode and 2048Kbps in non-framed mode
      • In framed mode, the PCM30/PCM31/PCM30C/PCM31C mode is optional
      • Supports DCE and DTE mode, in DCE mode, the master timing and tracing timing is optional; while in DTE mode, it only supports tracing V.35 timing
      • Supports phase settings between V.35 output data and clock
      • Supports link fault pass through function, which can notify V.35 port that the E1 side is failed
      • PCM interface
      • Up to 16 FXO / FXS / magneto interfaces
      • Up to 8 2/4-wire E&M audio interfaces
      • Up to 8 64K data/ RS232 /RS485 data
      • Ethernet Interface
      • Four LAN ports(physical port), each LAN port supports auto-negotiation, it can also be set to 10M full/half-duplex, 100M full/half-duplex mode by force
      • Four WAN ports (internal port and invisible), each WAN port employs a VCG; the total bandwidth of 4VCGs is 63 VC12 and the bandwidth of optional one VCG is up to 48 VC12(100Mbps)
      • The LAN and WAN ports are compatible with IEEE802.3/802.3u standard
      • Supports flow control and broadcast storm filtering control
      • Supports port-based VLAN and IEEE802.1Q tag-based VLAN
      • Supports GFP-F Encapsulation specification complying with ITU-T G.7041
      • Supports VCAT specification complying with ITU-T G.707
      • Supports LCAS specification complying with ITU-T G.7042
      • Provides both LCAS and Non-LCAS modes
      • The maximum tolerated differential delay between any two VC-12 channels is 112ms
      • SDH equipment timing mode
      • ITU-T G.813 internal oscillator
      • STM-1 line timing (T11,T12)
      • The timing source can be operated automatically or controlled.
      • Protection
      • Supports 1+1 path protection with switching time less than 50ms
      • Supports Automatic protection mode and manual protection mode
      • Supports embedded BERT and various loop back for troubleshooting
      • Supports FTP protocol and firmware download online without disturbance of existing traffic
      • NE Management
      • Provides serial management interface(CONSOLE) and Ethernet management interface (EMU), both adopt RJ45 connector
      • Supports network management based on SDH overhead or on internal E1 channel
      • Supports NE management based on CLI command via RS232 interface or TELNET
      • Supports RayView network management platform based on SNMP_V1 and SNMP_V2 protocol to perform excellent management
      • Supports hot-spare power, the power consumption is less than 15W /25W
      • -48V DC single power access
      • -48V DC double power access
      • 220V AC single power access
        220V AC double power access
        -48V DC+220V AC double power access
      •  

       

      PCM sub-module list

       

      Model

      Name

      Description

      PCM-4FXS

       

      Foreign exchange station module

      Provides a 4ch FXS interface, connects to user phone directly. Works with PCM-4FXO module to achieve extension of PBX user line

      PCM-4FXO

       

      Foreign exchange  office module

      Provides a 4ch FXO interface, connects to PBX user interface. Works with PCM-4FXS module to achieve extension of PBX user line.

      PCM-4MAG

      magneto telephone module

      Provides a 4ch magneto telephone interface, adopts 2100Hz inband signaling with signaling transmission and detection function, mainly apply to order wire, private line etc,. Occasions.

      PCM-2EM-2/4

      2/4 wire E&M audio module

      Provides 2ch 2/4 wire E&M audio without signaling, supports 2/4 Wire mode online switch.

      PCM-2RS232

       

      RS232 Interface module

      Provides a 2ch RS232 asynchronous interface, each channel occupies one 64K time slot. Supports rate from 0Kbps19.2Kbps.

      PCM-2RS485

       

      RS485 interface moudle

      Provides a 2ch RS485 asynchronism interface, each channel occupies one 64K time slot. Supports rate from 0Kbps19.2Kbps, half-duplex mode.

      PCM-2CD64K

      64K data module

      Provides a 2ch 64K data interface, complies with ITU-T G.703

       

      Application

       

       

      img2

      Figure 1 Point to point network

       

       

      img3

       

      Figure 2 Chain network

       

      img4

       

      Figure 3 Ring network

       

      未標題-1_03

       

       

      Figure 4 PCM application

       

      Note: Make sure optical A of one NE must be connected with optical B of its neighboring NE.

       

    • 0

    Other  Products

    ?Contact us
    Verification code

    Contact Form

    PRODUCTS

    自在自线亚洲а∨天堂在线_亚洲国产精品久久电影欧美_日本黄色免费播放视频网站_手伸进内衣使劲揉搓奶头漫画
  • <sup id="6ques"><button id="6ques"></button></sup>
  • <sup id="6ques"></sup>
  • <sup id="6ques"><button id="6ques"></button></sup>