• <sup id="6ques"><button id="6ques"></button></sup>
  • <sup id="6ques"></sup>
  • <sup id="6ques"><button id="6ques"></button></sup>

    CN | EN

        • Fiber Optic Intrusion Detection System

        • Fiber Optic Intrusion Detection System Solution

        • Fiber Optic Intrusion Detection System Classic Case Series

        • Fiber Optic Intrusion Detection System Video Introduction

      • HD-SDI Surge Protector
        RV705 HD-SDI Surge Protector

        4U Rack Mounting Chassis
        RV600C HD-SDI 4U Rack Mounting Chassis

        4U Rack Mounting Chassis
        RV600C HD-SDI 4U Rack Mounting Chassis

        HD-SDI Surge Protector
        RV705 HD-SDI Surge Protector

        • HIFI Audio Optical Transceiver

          ● RV6X4-2A         2-ch unidirectional HIFI
          ● RV6X4-4A         4-ch unidirectional HIFI
          ● RV6X4-4A-1U    4-ch unidirectional HIFI-1U
          ● RV6X4-8A         8-ch unidirectional HIFI
          ● RV6X4-2A-2BA   2-ch bidirectional HIFI
          ● RV6X4-4A-4BA   4-ch bidirectional HIFI

          ● Compact design with 1U height
          ● XLR interface for Audio
          ● SNR is better than 92dB
          ● 192K sampling frequency
          ● 24 bit quantized accuracy
          ● Provides AC110~220V dual power redundancy

        • SDI Converter

          ● 75ΩBNC connector for SDI input and looping out
          ● VGA output interface
          ● Two unbalanced RCA audio output with 600Ω impendence...

          ● Features 1 VGA input, 2 audio inputs and 1 SDI output
          ● Supports asymmetrical conversion for any format
          ● The input and output video format can be shown on the screen...

          75Ω BNC connector for SDI input and looping out

          ● HDMI output interface

          ● Two unbalanced RCA audio output with 600Ω impendence...

        • SDI Distribution Amplifier

        • 4U Rack Mounting Chassis

          ● 19 inch and 4U height
          ● 16 traffic card slots and 1 management card slot
          ● 3 fans embedded
          ● Dual power supplies for power redundant protection
          ● Provides one RS232 management interface(CONSOLE) used for CLI management...

        • HD-SDI Surge Protector

          and Pattern Generator

          ● Multi-level protection, low residual voltage
          ● Short response time   
          ● Large thermal capability and low limiting voltage
          ● Stable performance and long service life...

          ● Comply with SMPTE-424M 3G-SDI, SMPTE-292M HD-SDI and SMPTE-259M SD-SDI standard
          ● Support 1080P@59.94/29.97, 1080I@59.94, 720P@59.94, 525I@59.95 format of NTSC...

        • CHIP

        • Multi-Service Access Platform

          3U height, 19 Inch width standard, 9 card slots.

          Up to 2 GE optical ports and 2 GE electrical ports

          Aggregate the 1000M Ethernet traffic from up to 3 downlink cards...

          ● 7U height, 19 Inch width standard, 16 card slots.

          ● Up to 4 GE optical ports and 4 GE electrical ports.

          ● Each card can aggregate the 1000M Ethernet traffic from up to 8 downlink cards...

        • Converter

        • Compact SDH

        • Compact PDH

        • Channelized Industrial Ethernet switch

          Optical interface
          ● Two optical interfaces; SFP optical module (LC interface); Hot plugging...
          Ethernet interface
          ● RP105SA:One fiber and two copper Gigabit Ethernet interfaces
          ● RP106: Four fast Ethernet interfaces...

      • CONTACT US

      • Mobile: 86-13810132168
      • Tel: 86-10-80106100-157
      • Skype ID
      • live:d8d61896f81afc11
      • 服務時間

      • 周一至周五 9:00-18:00
      • WeChat qr code

    24545540
    12163701

    Simplified Ethernet to multi-E1 Converter (RB003)

    The RB003 series is the IP over TDM converter, which supports the conversion from MAC frames to 1 – 16 E1 lines. The maximum bit rate is 31.68Mbps (16E1 lines). It not only provides alarms and status of the E1 line and Ethernet interface together with advanced management functions, but also supports the Local/ remote monitor and management via CLI commands. With low power consumption.
    • 999999999999999

       

       

      Overview 

      The RB003 series is the IP over TDM converter, which supports the conversion from MAC frames to 1 – 16 E1 lines. The maximum bit rate is 31.68Mbps (16E1 lines). It not only provides alarms and status of the E1 line and Ethernet interface together with advanced management functions, but also supports the Local/ remote monitor and management via CLI commands. With low power consumption, high integration and well stability, it is a cost-competitive solution for the application in access network, such as the telecommunication, the electric power and the finance fields.

      Compliant to international standards, the device can communicate with products from other vendors adopting the same standards.

       

      Feature  

       

      • Compact design with 1U height, 19 inch, and can be installed on standard rack
      • Realizes Ethernet transparent transmission over 1~ 16 E1s
      • E1 interface
      • Provides 4/8/16 E1 interfaces, compliant to G.703, and balanced/unbalanced selectable
      • Jitter tolerance, jitter transfer characteristic and jitter generation fully comply with ITU-T G.823 and G.742 recommendations
      • Supports automatic removal and recovery of E1 channels that used for carrying payload. The E1 channels that have urgent alarm, such as LOS, AIS, LOF, LOMF, are removed automatically, and during this period, some Ethernet packets may be lost; It will be resumed when the fault dismisses
      • The differential delay between any two of the 16 E1 can be up to 220ms; when the factual differential delay exceeds 220ms, alarm is generated and Ethernet is cut off
      • The E1s in the local and remote side (E1 map) can be arranged arbitrarily
      • Ethernet interface
      • Provides up to 4 shared Ethernet interfaces, 4 electrical Ethernet interfaces(FE) or 3 FE plus one optical Ethernet interfaces(FX), compliant with IEEE802.3 serial standard
      • The FE interface supports auto-negotiation, which can work in 100M full/half-duplex, 10M full/half-duplex mode
      • The FX interface supports auto-negotiation, which can work in 100M full/half-duplex mode
      • 1024 MAC address table and 5-minute aging time
      • Accepts frames with length between 64 and 1916 bytes (otherwise filtering)
      • Supports MAC address dynamic learning function with aging time of 5 minutes
      • Supports flow control
      • Compliant to ITU-T standards
      • GFP-F encapsulation specified in ITU-T G.7041
      • Virtual concatenation (VCAT) specified in ITU-T G.7043
      • Link Capacity Adjustment Scheme (LCAS) specified in ITU-T G.7042
      • GFP frame mapping into single E1 channel specified in ITU-T G.8040
      • GFP frame mapping into nxE1 channel specified in ITU-T G.7043
      • Redundant power supply, the power consumption is less than 8W
      • -48V DC single power access
      • 220V AC single power access
      • 220V AC double power access
      • -48V DC double power access
      • -48V DC&220V AC double power access
      •  

      Product Options

       

      Table 1 Product type

       

      Product

      card type

      Ethernet interface

      E1

      Connector

      E1

      impedance(Ω)

      FE

      FX

       

      RB003

       

       

       

       

       

       

      RB003-4E1BNC-4FE

      4

      0

      4E1

      BNC

      75

      RB003-4E1BNC-3FE+1FX

      3

      1

      RB003-4E1RJ48C-4FE

      4

      0

      4E1

      RJ48C

      120

      RB003-4E1RJ48C-3FE+1FX

      3

      1

      RB003-8E1RJ48C-4FE

      4

      0

      8E1

      RJ48C

      120

      RB003-8E1RJ48C-3FE+1FX

      3

      1

      RB003-8E1BNC-4FE

      4

      0

      8E1

      BNC

      75

      RB003-8E1BNC-3FE+1FX

      3

      1

      RB003-16E1RJ48C-4FE

      4

      0

      16E1

      RJ48C

      120

      RB003-16E1RJ48C-3FE+1FX

      3

      1

      RB003-16E1DB37-4FE

      4

      0

      16E1

      DB37

      75

      RB003-16E1DB37-3FE+1FX 3 1

       

      Application

       

      Figure 4-1 illustrates a typical point-to-point application. With RB003 system, the Ethernet is transferred over 1~16E1s. Compliant to the international standards, the RB003 can communicate with products from different vendors, adopting the same standards.

      Note that RB003 can only support point-to-point application.

       

      img2

       

      Figure 1 Point-to-Point application

       

       

    • 0

    Other  Products

    ?Contact us
    Verification code

    Contact Form

    PRODUCTS

    自在自线亚洲а∨天堂在线_亚洲国产精品久久电影欧美_日本黄色免费播放视频网站_手伸进内衣使劲揉搓奶头漫画
  • <sup id="6ques"><button id="6ques"></button></sup>
  • <sup id="6ques"></sup>
  • <sup id="6ques"><button id="6ques"></button></sup>